BMW TIS Online
X

Uninstalling and installing trim centre console (PREMIUM) BMW 3 F30

51 16 160 

PRELIMINARY WORK

1 – Remove the decorative trim from the centre console

For equipment specification with in leather instrument panel: Attach plastic adhesive tape (2) between the decorative trim (1) and the instrument panel.

Detach the decorative trim (1) with the special tool 0 496 571 (00 9 327) from the clamps (2).

If necessary, unlock associated plug connections and disconnect.

Remove decorative trim (1) upwards.

2 – Detaching the gearshift lever cover

Pull installation frame of gaiter at the sides upwards out of centre console.

3 – Removing the operating unit for the centre console

Adhere to following procedure:

  1. Reach under front section of operating unit for the centre console (1).
  2. Press front latch mechanism in direction of arrow and simultaneously raise operating unitfor the centre console (1) towards top.
  3. Disconnect associated plug connection and remove operating unit for the centre console(1).

MAIN WORK

4 – Removing the trim for the centre console

Loosen screws (1).
Detach the trim for the centre console (2) using a special tool 0 496 569 (00 9 325) on the clamps (3).
Slightly raise the trim for the centre console (2) and disconnect the associated plug connections.
Remove the trim for the centre console (2) by guiding it in an upwards direction and to the rear.
5 – Installing the trim for the centre console

Do not detach springs (1) during installation.

Replace faulty clamps.

Connect all plug connections .

Position trim for centre console (2).

Clip in trim for centre console (2) at latch mechanisms (3).

Tighten the screws (1).

POSTPROCESSES

6 – Installing the operating unit for the centre console

Clip in the operating unit for the centre console.

7 – Installing the decorative trim to the centre console

Replace faulty clamps (1) of the decorative trim (2).

TECHNICAL INFORMATION
The controller may have to be remounted upon replacing the decorative trim, depending on the equipment specification.

For more information see: 6131195 Removing and installing (replacing) the controller

For equipment specification with in leather instrument panel: Attach plastic adhesive tape

(2) between decorative trim (1) and instrument panel.

Clip in the decorative trim (1) at the latch mechanisms (2).

8 – Installing the gearshift lever cover

Press the installation frame of gaiter on the sides and position.

Additional Information

Usage (Panel wedge) From 11/2008 this special tool replaces panel wedge 00 9 317 (different material)
Links Storage location Individual
Replaced by
In connection with
SI-Number 41 01 09 (507)
Repair instructions Used in step

Overview of Special Tools

0496 571 (00 9 327) Wedge

Common
Usage (Cleaning wedge) From 11/2008 this special tool replaces panel wedge 00 9 323 (different material)
Included in the tool or work 0 490 527
Storage location Individual
Replaced by
In connection with
SI-Number 01 07 09 (530)
0 496 569 (00 9 325) Wedge
Common
Usage (Panel wedge) From 11/2008 this special tool replaces panel wedge 00 9 317 (different material)
Included in the tool or work 0 490 527
Storage location Individual
Replaced by
In connection with
SI-Number 41 01 09 (507)



This post was last modified on December 17, 2017, 10:53 am

Categories: 51 Body equipment
Tags: bmw 3centre consolef30trim centre console
tisbimmer :
Disqus Comments Loading...

This website uses cookies.