BMW TIS Online
X

Tag: m60

Gas and GR Bowden cable BMW E31, E32, E34, E36, E38

00350501/0797 US models Situation: The gas Bowden cable and the Bowden cable of the cruise control system (GR) on the…

Replacing, sealing fuel hoses on engine BMW M43, M44, M60, M62

13 53 540  Warning! The fuel in the fuel lines is under pressure (approx. 3-5 bar)! Recycling Catch and dispose…

Replacing drive belt for a/c compressor on engine BMW M60, M62, M73

11 28 050  Note: If the drive belt is to be reused, mark direction of travel and reinstall drive belt in…

Replacing fuel filter on engines BMW M52, M60, M62, M73

13 32 051  Switch off ignition. Unfasten screws on lower trim (1). Fold lower trim to one side. Disconnect fuel…

Replacing air filter insert on engine BMW M60, M62

13 72 001  Open clips (1). engine BMW M60B30: Unfasten air hose (2), loosen hose connector and remove hose. Remove…

Replacing throttle valve potentiometer (ASC+T) on engine BMW M60, M62

13 63 556  Switch off ignition. Version 1: (acoustic cover screwed down) Remove seal caps (1) and unfasten nuts (2).…

Additional work with ASC+T (removing and installing throttle body ASC+T on throttle body) on engine BMW M60, M62

13 54 554 Disconnect plug connection on throttle valve potentiometer. Remove Bowden cable from throttle body ASC+T. Remove throttle body…

Removing and installing or replacing fuel pump BMW 7 E38 with engine M60, M62

16 14 010  Suck the fuel out of the fuel tank, refer to 16 00 005 Remove right sensor for…

Replacing temperature sensor for intake air on engine BMW M60, M62

13 62 511  Switch off ignition. Version 1: (acoustic cover screwed down) Remove seal caps (1) and unfasten nuts (2).…

Replacing throttle valve potentiometer on engine BMW M60, M62

13 63 555  Switch off ignition. Version 1: (acoustic cover screwed down) Remove seal caps (1) and unfasten nuts (2).…

Replacing tank vent valve on engine BMW M60, M62

13 90 500 Interrogate fault memory of DME control unit. Switch off ignition. engine BMW M60: The tank vent valve…

Replacing impulse sensor on engine BMW M60

12 14 520  Interrogate fault memory of DME control unit. Switch off ignition. Remove seal caps (1) and unfasten nuts…

Checking injector valves for leaks and cleaning BMW M60, M62

13 64 582 Injector valves removed. Mark sequence of injector valves relative to cylinders on each injector valve. Caution! Observe…

Checking one valve guide for wear on engine BMW M60

11 12 595  (Valve removed) To measure tilt clearance, insert new valve so that valve stem end is flush with…

Replacing crankshaft radial sealing ring on engine BMW M60

11 14 151  (Transmission side) Remove transmission. Drain engine oil. This operation is described in section on BMW engine oil…

Removing and installing, replacing upper oil sump section on engine BMW M60, M62

11 13 510  (engine removed) Secure engine to special tool 00 1 450. Remove lower oil sump section. Remove guide…

Removing and installing, replacing complete main flow oil filter on engine BMW M60

11 42 020 Unfasten oil filter cover to allow oil to flow out of main flow oil filter housing and…

Removing and installing or replacing piston for chain tensioner on engine BMW M60, M62

11 31 090 Remove upper section of suction filter housing style with mass air flow sensor. Remove lower section of…

Removing and installing, sealing both cylinder head covers on engine BMW M60

11 12 004 Note instructions on connecting and decoupling battery, refer to General Information MG12 Disconnect negative battery lead. Pry…

Removing and installing, replacing all pistons on engine BMW M60

11 25 530  (engine removed) Removal Removal of pistons is described separately from installation. Assembly sequence for removal and installation…

This website uses cookies.