BMW TIS Online
X

cylinder head

Removing and installing, sealing right cylinder head cover on engine BMW N63

11 12 006 Necessary preliminary tasks: Remove acoustic cover Disconnect negative battery terminal Release battery positive terminal Drain coolant Remove…

Tightening Torques for Cylinder head with cylinder head cover engine BMW N63

11 12  Type Thread Tightening specifications Torque 1AZ Cylinder head bolt N63 M11 x 1.5 Replace screws. with part number…

Dismantling and assembling the cylinder head on engine BMW M73

11 12 503  (cylinder head removed) Remove exhaust manifold. Secure special tool 11 1 065 to special tool 00 1…

Removing and installing, sealing rear left end cover on cylinder head (cylinder bank 7-12) on engine BMW M73

11 14 190  Remove left cylinder head cover, refer to 11 12 004 Remove rear coolant manifold, refer to 11…

Replacing both cylinder head gaskets on engine BMW N63

11 12 112  Necessary preliminary tasks: Remove left cylinder head. Remove right cylinder head. Installation note: The cylinder head gasket…

Removing and installing left cylinder head on engine BMW M73

11 12 105 Remove upper section of timing case, refer to 11 14 102 Remove splash guard. Remove left and…

Checking cylinder head for water leaks on engine BMW M73

11 12 729  (cylinder head dismantled) Seal coolant apertures with special tool kit 11 1 420 comprising special tool 11…

Replacing right cylinder head gasket on engine BMW M73

11 12 111  This operation is described in section on ” Removing and installing right cylinder head ”, refer to…

Removing and installing right cylinder head on engine BMW M73

11 12 516  (engine removed) Secure engine to special tool 00 1 450. Operation is described in section on removing…

Removing and installing left cylinder head on engine BMW M73

11 12 515  (engine removed) Raise engine with special tool 11 0 000. Caution! Only raise engine on locating lugs…

Removing and installing, sealing rear right end cover on cylinder head (cylinder bank 1-6) engine BMW M73

11 14 192 Remove right cylinder head cover, refer to 11 12 004 Unfasten rear cable tie on cylinder head.…

Removing and installing right cylinder head on engine BMW M73

11 12 106 Remove upper section of timing case, refer to 11 14 102 Remove splash guard. Remove left and…

Removing and installing / sealing left cylinder head cover on engine BMW M73

11 12 005 refer to 11 12 004    

Replacing left cylinder head gasket on engine BMW M73

11 12 110  This operation is described in section on ” Removing and installing left cylinder head ”, refer to…

Mill down cylinder head sealing face engine BMW M73

11 12 719  (cylinder head dismantled) Check evenness of cylinder-head ceiling surface with straight edge (commercially available). Deviation from planeness…

Replacing both cylinder head gaskets on engine BMW M73

11 12 112  Remove both cylinder heads. These operations are described in section on ”Removing and installing left cylinder head…

Removing cylinder head cover on engine BMW M50 VANOS

11 00 If applicable, pull connectors off ignition coils. Unscrew nuts. Remove ignition coils. Installation: Check for earth strap of…

Disassembling and assembling cylinder head, mounting cylinder head on assembly fixture for engine BMW M50 VANOS

11 00 Fit special tool 11 1 065 to special tool 00 1 490. Do not install special tool 11…

Removing and installing or sealing cylinder head cover on engine BMW M50

11 12 000 If necessary, remove air manifold box. Place cable channel to one side. Unscrew cover for ignition coils.…

Removing and installing, sealing cylinder head cover on engine BMW S55

11 12 000  Necessary preliminary tasks: Remove right trailing link Release engine wire harness in the area of the cylinder…

This website uses cookies.