BMW TIS Online
X

Replacing rubber sleeve between fuel filler pipe and fuel tank BMW E70 X5 4.8i SAV

16 11 071 

Recycling

Fuel escapes when fuel lines are detached. Have a suitable collecting container ready.

Catch and dispose of escaping fuel.

Observe country-specific waste-disposal regulations.

Important!

Ensure adequate ventilation in the place of work!

Avoid skin contact (wear gloves)!

Before starting the engine for the first time:

Fill fuel tank with at least 5 litres of fuel.

Necessary preliminary tasks:

Draw off fuel from fuel tank

Remove underbody panelling on right

Remove rear right wheel arch trim

Unclip line holder (1).

Slacken nut (2).

Installation:

Check plastic nut (2), replace if necessary.

Tightening torque 16 12 2AZ.

Important!

There may be residual amounts of fuel in the tank!

Catch escaping fuel in a suitable container.

Loosen hose clamps (1).

Detach rubber sleeve first from fuel filler pipe and then from fuel tank.

Installation:

Tightening torque 16 11 3AZ.


Categories: 16 Fuel supply system
Tags: bmw x5e70fuel filler pipeFuel tankrubber sleeve
tisbimmer :
Disqus Comments Loading...

This website uses cookies.