33 32 195 

Special tools required:

33 4 462
33 4 463
33 4 464
33 4 465
33 4 466
33 4 455
33 4 456
33 4 452
33 4 451
2 361 896
2 361 891
33 4 450

Note:

If the camber arm is detached from the rear axle support/wheel carrier, it is necessary after installation to carry out a wheel alignment.

Necessary preliminary tasks:

Remove coil spring, rear.

Removal:

Replacing rubber mount for camber arm in rear axle support BMW M2 F87

Left only:

Slacken nut (1).

Release jointed rod (2) from camber control arm.

Replacing rubber mount for camber arm in rear axle support BMW M2 F87

Slacken nut (1).

Pull out screw (2).

Swivel camber control arm (3) downwards and allow to hang on wheel carrier.

Replacing rubber mount for camber arm in rear axle support BMW M2 F87

Remove rubber mount using special tools 33 4 462 , 33 4 463 , 33 4 464 , 33 4 465 and 33 4 466 .

Installation:

Replacing rubber mount for camber arm in rear axle support BMW M2 F87

Pull together rubber mount with special tools 33 4 455 , 33 4 456 , 33 4 452 and 33 4 451.

Replacing rubber mount for camber arm in rear axle support BMW M2 F87

Draw rubber mount into rear axle support so that the slot (1) is vertical at the top.

Replacing rubber mount for camber arm in rear axle support BMW M2 F87

Draw rubber mount into rear axle support as far as possible using special tools 2 361 896 , 2 361 891 , 33 4 466 and 33 4 465 .

Remove special tool 33 4 450 and pull in rubber mount until limit position.

Replacing rubber mount for camber arm in rear axle support BMW M2 F87

Swivel camber control arm (3) upwards and position on rear axle support.

Part: Replace nut (2) and bolt (1).

Insert bolt (2).

Pay attention to direction of insertion of the screw (2).

Screw on nut (1) and tighten in normal position.

Tightening torque 33 32 7AZ.

Replacing rubber mount for camber arm in rear axle support BMW M2 F87

Left only:

Insert jointed rod (2) at camber control arm.

Part: Replace nut (1).

Tighten nut (1).

Tightening torque 37 14 4AZ:

Type Thread Tightening specifications Torque
1AZ Ride height sensor holder to front axle support
F80 / F82 / F83 / F87 M12 Renew screw and nut.
Jointing torque 100 Nm
Angle of rotation 90 °
2AZ Ride height sensor holder to rear axle
F80 / F82 / F83 / F87 M6 8 Nm
3AZ Ride height sensor to holder
F80 / F82 / F83 / F87 M5 5 Nm
4AZ Jointed rod to ride height sensor and camber arm
F80 / F82 / F83 / F87 M6 Renew nut. 8 Nm
5AZ Vertical acceleration sensor to spring strut/shock absorber
F80 / F82 / F83 6 Nm
6AZ EDC control unit with control unit holder to body
F80 / F82 / F83 3 Nm

Required follow-up work:

Install rear coil spring.
Carry out wheel alignment procedure.