24 34 561

Important!

After completion of work, check transmission oil level.

Use only approved gearbox oil.

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Important!

Read and comply with notes on protection against electrostatic discharge (ESD protection).

Necessary preliminary tasks:

E60/ E61/ E63/ E64, E70 N62/N62TU only:

Remove exhaust system.

If necessary, release cross member from exhaust system on transmission.

If necessary, remove heat shield on left and right.

Remove transmission cross member.

Note:

Version 1:

Unfasten nut.

Remove cable (1).

Installation note:

Adjusting gearshift lever

Note:

Version 2:

Grip clamping bush (1) and slacken nut (2).

Detach clamp (3) towards bottom using a screwdriver.

Pull cable (4) out of holder.

Installation note:

Adjust gearshift lever.

Note:

Version 3:

Release screw (1).

Remove clamping bracket (2).

Release shift cable head (3) using a screwdriver from ball head of shift cable lever.

Installation note:

Adjust gearshift lever.

Note:

Version 4:

Unfasten nut.

Remove cable (1).

Installation note:

Adjust gearshift lever.

Secure lever (1) with a cable strap (2) or wire in vertical position.Note:

Illustration shows E65.

Important!

Mechatronics can be destroyed by static discharges. Therefore the contacts inside the connector must not be touched. Insert special tool immediately after operation.

Unscrew connector (1) and disconnect.

Insert special tool 24 2 390 in sealing cup (1).

Remove transmission oil sump.

Unlock sealing sleeve with slide (1).

Note position of sealing cup.

Pull out sealing cup (1).

Installation note:

Screw in sealing sleeve partially (lug in upper area). Turn until lug engages in groove of transmission. Slide in sealing cup.

Lug on sealing cup must not be damaged!

Important!

E65/66 only:

Mechatronics without protective bar for solenoid valve must not be reused after removal.

Important!

E65/66 only:

Fit/reuse only mechatronics with protective bar (1) for solenoid valve.

Installation note:

Check gaskets (1 and 2) for damage, replace gaskets if necessary.

Coat new gaskets with automatic transmission fluid and install.

Installation note:

Insert screws (3) alternately until contact is made with each screw head.

Insert all further screws contact is made with each screw head.

Note:

GA6HP26Z, GA6HP32Z

Important!

Tighten down screws in order 1…10.

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Tightening torque 24 30 1AZ.

Note:

GA6HP26TU, GA6HP32TU

Important!

Tighten down screws in order 1…13.

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Tightening torque 24 30 1AZ.