Replacing ignition coil BMW engine S54

12 13 511

Turn off the ignition.
Remove heater bulkhead.

Disconnect the hose (1) crankcase ventilation system.
Release screws.
Unscrew the lid (2) the oil filler hole.
Remove the cover.
Изображение

Unlock the lock (1) the ignition coil connector.
Изображение

Disconnect the connector (1) from the ignition coil.
Изображение

Remove the ignition coil.
This procedure removes all the candles.
Installation:
Tide on the head (2) must enter the cylinder block through the hole from the lower side (1) of the rubber gaskets.
Изображение

Note:
Read fault memory of DME control unit.
Check stored fault messages.
Rectify faults.
Erase fault memory.