BMW TIS Online
X

Replacing idle speed control valve BMW M43 engine 09/1995, M43TU, M44


Replacing idle speed control valve BMW M43 engine 09/1995, M43TU, M44

13 41 500

Turn off the ignition.
Disconnect the connector (1).

Disconnect the vacuum hose at the point of connection (2).
Release screws (3) and remove the control of idling.

Check sealing surface and seal the valve idling for damage. Clean sealing surface and, if necessary, replace the seal.

Installation:
Secure the valve inlet hose idling in the holder (1) in the suction hose.

Read fault memory of the DME control unit malfunctions, check messages, rectify faults and clear information.


This post was last modified on December 7, 2016 9:29 am

Categories: 13 Fuel system
Tags: idle speed control valvem43m43tum44
tisbimmer :
Disqus Comments Loading...

This website uses cookies.