BMW TIS Online
X

Replacing a drive throttle cable BMW engine M43, M52


Replacing a drive throttle cable BMW engine M43, M52

35 41 421

After installation, adjust the cable,
see. 35 … 41

Remove trim pedal mechanism,
see. The core group (HG) 51.
Remove the heater walls,
see. The core group (HG) 51.

The engine BMW M43:
Remove the cap (1).

The engine BMW M43:
Remove the adjusting bolt (1) of rubber mount (2). Squeeze the rubber mount (2) from its holder.
Pull the tip of the arm (3).

The engine BMW M52:
Remove the adjusting bolt (1) from the support.
Pull the tip of the arm (2).
Note:
For greater clarity, the intake manifold is removed.

Disconnect the tip (3) of the accelerator pedal arm.
Compress the locking grommet hooks (1) and pull the throttle control cable from the engine compartment partition (2).

Remove the cable with the grommet (1) and rubber grommet (2).
Installation:
Groove grommet (1) must be located on the lip (3) walls. Pull the rope to check whether the locking hooks snap into place. Insert the rubber grommet (2).


Categories: 35 Pedals
Tags: m43m52throttle cable
tisbimmer :
Disqus Comments Loading...

This website uses cookies.