Removing and installing trunk lid BMW 3 E46
Trunk lid, hinges and gas-filled shock absorber
Изображение
1 – boot lid
2 – sealing gasket
3 – loop
4 – stop
5 – rubber cover
6 – gas filled stop
7 – stop
8 – stop
9 – handle with gasket
10 – a light disk (for a lamp of illumination of license plate)
11 – key with microswitch
12 – pressure plate
13 – the lock of the cylinder of the lock
14 – connecting rod
15 – nut
16 – the lock
17 – the lock of the lock
18 – a lining of the cylinder of the lock
19 – cylinder of the lock
20 – film
21 – nut
22 – license plate holder
23 – distance washer
24 – felt
25 – washer
26 – self-tapping screw
27 – cover
REMOVAL
1. Disconnect the trunk lid trim.
2. Pull the cable harness out of the boot lid. To do this, undo the plug connections of the license plate and single lock lighting. Secure the cord to the plugs and pull out the harness.
Caution: The cord remains in the boot lid and serves to facilitate the installation of cables.
3. Mark the position of the trunk lid at the hinges. To do this, trace the bar of the loop with a felt-tip pen.
Изображение
4. Support the boot lid securely and ask her to hold the assistant.
5. Loosen the screws left and right -2-, remove the screw -3-, 4-stop.
INSTALLATION
7. Replace the trunk lid with the assistance of an assistant. Screw in the screw -2- without tightening it.
8. Reinstall the boot lid according to the markings and secure.
9. If the lid is replaced, fit it.
10. Insert the electrical wires of the license plate light and single lock lamp with the cord into the boot lid and dock them.
11. Fix the lining, replace the damaged clamps.