BMW TIS Online
X

Removing and installing, sealing or replacing oil sump BMW (N57)

11 13 000

Necessary preliminary tasks:

Remove acoustic cover Remove fan cowl.

Remove engine underguard at front/rear.

Remove starter motor.

Drain engine oil.

Remove front axle differential (AWD).

Removing bearing support (all-wheel drive).

Lower front axle support.

Note:

Front axle alignment is not required.

Unclip wiring harness (1) from holders (2).

Release screws (1).

Tightening torque 11 13 2AZ.

Figure without transmission.

Release screws (1).

Tightening torque 11 13 2AZ.

Installation note:

Tighten down all screws diagonally and evenly.

Release screws (1).

Tightening torque 11 13 2AZ.

Disconnect plug connection on oil level sensor.

Installation note:

Pay attention to cable holder.

Release screws (1).

Tightening torque 11 13 2AZ.

Remove gasket (1).

Remove gasket debris from sealing face and clean sealing face.

Install oil sump with a new gasket.

Installation note:

Special tool 11 8 780 is only necessary if transmission is removed.

Position special tool 11 8 780 with transmission bolts (1) so that engine oil sump is exactly flush with engine block.

Secure engine oil sump.

Assemble engine.


This post was last modified on July 3, 2017, 10:56 am

Categories: 11 Engine
Tags: N57oil sump
tisbimmer :
Disqus Comments Loading...

This website uses cookies.