BMW TIS Online
X

Removing and installing, replacing video module on-board monitor BMW X3 E83

Removing and installing, replacing video module on-board monitor BMW X3 E83

A warning!
Observe instructions for ESD protection (ElectroStatic Discharge)!

Necessary preliminary operations:
Disconnect the negative battery cable.
Remove the valve in the left luggage compartment cover.

Unlock and detach connectors (1).
Installation:
Do not confuse the connectors (2) of the antenna.
Mark and disconnect the antenna connector (2).
Release screws (3).
Release nut on hairpin (4).
Remove the on-board monitor video module (5) with the bracket from the stud (4) and pull it out in the direction of the arrow.

Release screw (1).
Unclip the wiring harness (2) from the clips at point (3) and pull out the video monitor module (4) of the on-board monitor with the bracket (5) from the side niche slightly.


Disconnect the on-board monitor video module (4) from the bracket (5) in the direction of the arrow and remove.

When replacing:
Perform coding, programming.


Categories: 65 Audio, navigation and information system
Tags: e83on-board monitorx3
tisbimmer :
Disqus Comments Loading...

This website uses cookies.