Removing and installing, replacing the master cylinder clutch BMW 5 E39

21 52 500

Note:
After completing work, bleed clutch hydraulic,
see. 21 00 006.

Remove microfilter housing (1).
Изображение

Draw off brake fluid to level supply line hydraulic drive (1) clutch. The device used for this purpose must be used exclusively for pumping the brake fluid.
Disconnect the supply line (1) from the tank.
Изображение

Remove the left lower trim of the instrument panel.

Remove the clip (1) and remove the pin.
Изображение

Release screws.
Изображение

Remove the bracket (1).
Note:
Avoid spilling brake fluid on the interior carpet.
Disconnect from the master cylinder (2) clutch lines to the slave cylinder and remove it along with the supply line.
Изображение

Use a screwdriver to remove the module (1) switch from the master cylinder (2) clutch.
Unlock connector (3) and disconnect the connector (4) on the module (1) switch.
Изображение

Installation:
Switch module is protected against improper installation.
switch module must engage with an audible click.
Изображение