BMW TIS Online
X

Removing and installing, replacing the engine oil pump BMW M52TU, M54, M56

Removing and installing, replacing the engine oil pump BMW M52TU, M54, M56

11 41 000

Remove the oil pan.
A warning!
Left-hand thread.
Unscrew the nut.
Installation:
Tightening torque, 11 41 4AZ.

Remove the sprocket chain drive with a fixed chain.
Installation:
Align the ring gear sprocket and oil pump shaft relative to each other.

Version 1
The oil pump is built into the damper oil level.
Release screws (1) and remove the oil pump with damper oil level.

Version 2
The oil pump and damper oil level two separate parts:
Unscrew the bolts and remove the suction pipe of the oil pump.

Version 2
The oil pump and damper oil level two separate parts:
Unscrew the bolts and remove the oil pump.

Installation:
Check dowel sleeves (1) for damage and correct installation.

Installation:
Replace O-ring on the suction pipe.

If necessary, remove the piston temperature controlled.
Push down on the sleeve appropriate rod.
A warning!
Bushing temperature-controlled piston is under spring pressure.
Remove the retaining ring.

Installation:
1. The temperature-controlled piston
2. Spring
3. Bushing
4. O-ring (replace)
5. Retaining Ring

Categories: 11 Engine
Tags: Engine M52TUengine m54engine m56
tisbimmer :
Disqus Comments Loading...

This website uses cookies.