Removing and installing, replacing the engine oil pump BMW M52TU, M54, M56

11 41 000

Remove the oil pan.
A warning!
Left-hand thread.
Unscrew the nut.
Installation:
Tightening torque, 11 41 4AZ.
Изображение

Remove the sprocket chain drive with a fixed chain.
Installation:
Align the ring gear sprocket and oil pump shaft relative to each other.
Изображение

Version 1
The oil pump is built into the damper oil level.
Release screws (1) and remove the oil pump with damper oil level.
Изображение

Version 2
The oil pump and damper oil level two separate parts:
Unscrew the bolts and remove the suction pipe of the oil pump.
Изображение

Version 2
The oil pump and damper oil level two separate parts:
Unscrew the bolts and remove the oil pump.
Изображение

Installation:
Check dowel sleeves (1) for damage and correct installation.
Изображение

Installation:
Replace O-ring on the suction pipe.
Изображение

If necessary, remove the piston temperature controlled.
Push down on the sleeve appropriate rod.
A warning!
Bushing temperature-controlled piston is under spring pressure.
Remove the retaining ring.
Изображение

Installation:
1. The temperature-controlled piston
2. Spring
3. Bushing
4. O-ring (replace)
5. Retaining Ring
Изображение