BMW TIS Online
X

Removing and installing, replacing right intake plenum on engine BMW N63

11 61 068 

Necessary preliminary work:

Remove right injection pipe.

Remove throttle valve

Release screws on intake plenum from above without fail before lowering front axle.

Secure engine in installation position.

Lower front axle, releasing screws on engine mount first Release A/C compressor and place to one side.

Detach engine ventilation hose (1).

Disconnect connector.

Unscrew nuts (2).

Tightening torque: 11 61 1 AZ:

Type Thread Tightening specification Torque
1AZ Intake manifold to cylinder head
N63 M7 15 Nm

Remove throttle valve (2).

Release screw (1).

Tightening torque: 11 61 2 AZ:

2AZ Holder, intake module, to cylinder head
N63 M6 10 Nm

Feed out intake plenum towards rear.

Installation note:

Replace all profile seals.

Assemble engine and vehicle.

Check air intake system for leaks.


Categories: 11 Engine
" tisbimmer : ."
Disqus Comments Loading...

This website uses cookies.