BMW TIS Online
X

Removing and installing, replacing hydraulic control unit Jatco A5S 300J


Removing and installing, replacing hydraulic control unit Jatco A5S 300J

24 30 008

Note:
Remove oil sump, refer to. 24 11 009
Remove the oil strainer, see. 24 31 158

Disconnect plug connections (1 – 3) from the holders of the hydraulic control unit and separate them.
Fold the mounting plate and remove them from the cable.

Disconnect the connector (1)
Remove the sensor (2) from its holder.

Remove the bolts (A, B, C) (17 pieces).
Installation:
Bolts (A) M6x45
Bolts (B) M6x40
Bolts (C) M6x33

A warning!
Do not damage the gasket between the hydraulic control unit and the gearbox case.
The hydraulic control unit to hold his hand.
Remove the bolts (A, C) and carefully remove the hydraulic control unit.
Installation:
Bolt (A) M6x45
Bolt (C) M6x33
Secure the hydraulic control unit with the bolts (A, C).
Screw the remaining screws to fit heads to the control unit. Tighten the bolts.
Tightening Torque, refer to. Specifications 24 30 1AZ

Installation:
Ensure that the pin with a clip (1) is located in the recess (2) of the control piston.

Installation:
The spring (1) of thin spring wire
Spring (2) Thick spring wire


This post was last modified on December 1, 2016, 3:22 pm

Categories: 24 Automatic transmission
Tags: hydraulic control unitJatco A5S 300J
tisbimmer :
Disqus Comments Loading...

This website uses cookies.