31 35 000 

Necessary preliminary tasks:

Remove stiffening plate

Removal:

Removing and installing, replacing front anti-roll bar BMW M2 F87

Release nut (1) of left and right screw fittings on anti-roll bar.

If necessary, hold up at the Torx socket.

Release left and right anti-roll bar link (2) from anti-roll bar.

Removing and installing, replacing front anti-roll bar BMW M2 F87

Release screws (1).

Remove bottom cover of steering assemblies (2) on left and right.

Removing and installing, replacing front anti-roll bar BMW M2 F87

Unscrew nuts (1).

Remove anti-roll bar (2).

Installation:

Removing and installing, replacing front anti-roll bar BMW M2 F87

Replacement:

Remove retaining brackets (1).

Using a screwdriver as necessary, retract on both sides between retaining bracket (1) and rubber mount lower section (3).

Detach rubber mount lower section (3) and upper section (2).

Removing and installing, replacing front anti-roll bar BMW M2 F87

Replacement:

Installation note:

Keep retaining bracket (1), top part of the rubber mount (2), bottom part of the rubber mount (3) and anti-roll bar clean and free of oil and grease.

Insert the top part of the rubber mount (2) into the retaining bracket (1). In the process, the guide (4) must be correctly positioned on the opening (5).

Latch mechanisms on the bottom part of the rubber mount (3) must not be damaged and must rest on the intended recessed in the retaining bracket (1).

Removing and installing, replacing front anti-roll bar BMW M2 F87

Replacement:

Position rubber mount lower section (3) and upper section (2) on anti-roll bar.

Connect retaining bracket (1) to rubber mount.

Using suitable pliers as necessary, press together the retaining bracket (1) and the rubber mount lower section (3) and interlock them.

Removing and installing, replacing front anti-roll bar BMW M2 F87

Replacement:

Ensure that the rubber mount parts are correctly seated on the limit position (1) of the anti-roll bar.

Important!

Please ensure that the bottom part of the rubber mount latches correctly on both sides when fitting the anti-roll bar!

To avoid complaints about noise (such as groaning), set the vehicle on its wheels and tighten down the anti-roll bar mount to specified torque!

Removing and installing, replacing front anti-roll bar BMW M2 F87

Position anti-roll bar (2).

Part: Replace nuts (1).

Tighten down nuts (1).

Tightening torque 31 35 1AZ:

Type Thread Tightening specifications Torque
1AZ Anti-roll bar bracket to front axle support
F80 / F82 / F83 / F87 M8 Replace nuts. 28 Nm

Removing and installing, replacing front anti-roll bar BMW M2 F87

Position lower cover of left and right steering assemblies (2).

Tighten down screws (1).

Required follow-up work:

Remove stiffening plate