BMW TIS Online
X

Removing and installing, replacing entrance cover strip, rear (inside) left or right BMW 7 E65

51 47 030 

Necessary preliminary tasks:

Version with rear seat (normal) only
Remove rear seat.
Version with rear seat (comfort) only
Move rear seat completely towards front and top.

Press entrance cover strip (1) at front towards bottom and feed out from door pillar trim (2).

Remove entrance cover strip (1) at front from clips (2) of door pillar.

Release plastic nut (1).

Feed cover strip (2) forwards and upwards out of trim (3) if necessary with aid of fishbone 00 9 321 and remove.

If necessary, lever clips with end cutting pliers (head of pliers surface-ground) out of door pillar.

Note:

If necessary, detach mucket before removing trim on rear comfort seat.

Installation:

Feed in guide lugs (1) under trim (2).

Installation:

If necessary, replace faulty clips (1).

Clip mounts of entrance cover strip (2) must not be damaged.

Push clips (1) onto entrance cover strip (2).


Categories: 51 Body equipment
Tags: bmw 7e65entrance cover strip
tisbimmer :
Disqus Comments Loading...

This website uses cookies.