BMW TIS Online
X

Removing and installing, replacing a front ultrasonic sensor (outer) (Park Distance Control) BMW 3 E90

66 20 518 

Necessary preliminary work:

Remove front wheel arch cover (front section)

Disconnect plug connection.

Unlock retaining tabs (1) in direction of arrow and pull ultrasound transducer (2) upward out of bracket (3).

Installation note:

Before installation of ultrasonic sensor (2) on wiring harness, clean plug connection!

Retaining hooks (1) of ultrasonic transducer (2) must engage exactly in mountings (3).

Installation note:

Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).


tisbimmer :
Disqus Comments Loading...

This website uses cookies.