BMW TIS Online
X

Removing and installing, renewing oil feed line for exhaust turbocharger BMW N63O1

11 42 200

Necessary preliminary tasks:

Remove alternator.

Remove both exhaust turbochargers.

Remove both exhaust manifolds.

Remove heat shield at bottom.

Important!

Remove foreign matter before loosening screw (1).

Release screw (1). To avoid contamination, use a clean cloth to close off the main oil duct.

Remove the oil feed line (2).

Tightening torque: 11 42 3AZ:

3AZ Turbocharger oil line to crankcase
N63O1 M6x18 Replace O-ring 10 Nm

Installation note:

Replace O-ring.

Reassemble the vehicle.


Categories: 11 Engine
Tags: exhaust turbochargerfeed linen63N63O1
tisbimmer :
Disqus Comments Loading...

This website uses cookies.