BMW TIS Online
X

Removing and installing rear bumper trim BMW Z4 E85

51 12 156 

Version with PDC:

Remove panel in luggage compartment at top right

Remove right trim for rear light (1) in luggage compartment.

Pull out luggage compartment wheel arch trim (2) in inwards direction slightly.

Disconnect plug-in contact (1).

Feed back cable and press through with grommet (2) outwards.

Version with TV function:

Remove panel in luggage compartment at top left

Turn turn-lock fastener (1) in direction of arrow and remove left trim (2).

Pull out luggage compartment wheel arch trim (1) in inwards direction slightly.

Disconnect plug-in contacts (2).

Feed back cable and press through with grommet outwards.

Note:

The operation is described on the left side; proceed in the same way for the right side.

Unfasten screws (1 and 4).

Press wheel arch trim (2) and heat shield (3) to side slightly.

Release nut (5) and disconnect ground cable (6).

All versions:

Release screws (1).

Release expansion rivets (1) on left/right.

Unclip bumper trim (2) in area (1) on left/right outwards.

Pull bumper trim (2) a little in direction of arrow and disconnect plug connections on license plate lights (3).

If necessary, feed out cable for PDC or TV.

Remove bumper trim (2) with aid of a second person.


Categories: 51 Body equipment
Tags: bmw z4bumperbumper trime85pdcrear bumperz4
tisbimmer :
Disqus Comments Loading...

This website uses cookies.