BMW TIS Online
X

Removing and installing rear bumper assembly of the BMW 5 E39


Removing and installing rear bumper assembly of the BMW 5 E39

51 12 000

Note:
Version with a towing device:
Remove the bar.

Lever out rivets with spacers on the left and on the right side and remove the side panels (1) wheel arch.

Version with signaling Park Distance Control (PDC):
Release collar harness.
Loosen the clamp and disconnect the connector and wire post.

Release inner nuts on the left and on the right side.
Tightening Torque, refer to. Specifications 51 12 2AZ
Version without signaling Park Distance Control (PDC):
Remove the bumper forwards.

Version with signaling Park Distance Control (PDC):
Pull bumper back a little, pull out the tip of the wires and the wires themselves.
Remove the bumper forwards.

Installation:
Put the seal (2) on the shock damper (1).
Put the protective cap (3) to right shock damper (1).

Ideal position:
The distance (A) between the bumper and the body aperture must be the same throughout its length.
The value (A) = 5 BMM

Loosen the inner nut on the left and right and adjust the height of the bumper.
Tightening Torque, refer to. Specifications 51 12 2AZ


Categories: 51 Body equipment
Tags: bmw e39bumperrearrear bumper
tisbimmer :
Disqus Comments Loading...

This website uses cookies.