BMW TIS Online
X

Removing and installing or replacing clutch release bearing, lever engine BMW M50 BMW 5 E34, BMW 3 E36

21 51 500

(transmission removed)

Detach release bearing (1).

Installation:

Clean all sliding surfaces on clutch release bearing, check for damage and replace if necessary.

Do not grease clutch release lever.

Sliding surfaces (2) of clutch release bearing must rest on sliding surfaces (3) of release lever.

Lightly grease sliding surfaces (2) of release bearing.

Grease, refer to BMW Service Operating Fluids.

Withdraw release lever (4) from spring wire clip (5) and remove.

Installation:

Clean release lever.

Lightly grease release lever at sliding surfaces (1 and 2) only.

Grease, refer to BMW Service Operating Fluids.

Installation:

Check spring wire clip (5) and ball pin (6) for damage and replace if necessary.

Lightly grease ball pin (6).

Grease, refer to BMW Service Operating Fluids.

Note:

The spring wire clip and ball pin must always be replaced on the S6S 420G transmission.

Clean guide sleeve (7).

Important!

Do not grease guide sleeve.
If guide sleeve is greased, the release lever can stick on the guide sleeve.


This post was last modified on July 19, 2017 12:05 pm

Categories: 21 Clutch
tisbimmer :
Disqus Comments Loading...

This website uses cookies.