35 11 000 

Note:

Remove and install panel for instrument panel, refer to Gr. 51.
Remove brake light switch, if necessary remove clutch switch, refer to Gr. 61.

Removing and installing mounting block for pedals BMW 3 E36

Unscrew and pull out screws (1 and 3). Take off holder for brake-light and clutch switches.
Place clutch cylinder to one side.

Installation:

Replace self-locking nut of screw (1).

Removing and installing mounting block for pedals BMW 3 E36

Screw (3) holds retaining plate for clutch and brake-light switches.

Installation:

Make sure line (2) is laid without kinks.

(1) and (3) = clutch-cylinder screws.

Removing and installing mounting block for pedals BMW 3 E36

Remove locking clip for shaft pin of clutch cylinder.

Version with return spring for clutch pedal:

Disconnect return spring.

Push out shaft pin.

Installation:

Grease sliding surfaces, refer to Technical Data.

Removing and installing mounting block for pedals BMW 3 E36

Version with over-center helper spring for clutch pedal:

Hold clutch pedal tightly.

Push out shaft pin.

Pull up clutch pedal slowly.

Take off over-center helper spring.

Installation:

Grease sliding surfaces, refer to Technical Data.

Make sure spring holder is seated correctly in mounting block.

Removing and installing mounting block for pedals BMW 3 E36

Assembly of over-centre helper spring:

  1. Spring retainer
  2. Over-center helper spring
  3. Guide pin
  4. Bearing shaft
  5. Locking clip

Removing and installing mounting block for pedals BMW 3 E36

Over-center helper spring from model 3/97:

  1. Spring retainer, black
  2. Over-center helper spring
  3. Spring retainer, gray

Removing and installing mounting block for pedals BMW 3 E36

Disconnect return spring for brake pedal.

Take off locking clip for shaft pin of brake pedal.

Push out shaft pin.

Installation:

Grease sliding surfaces, refer to Technical Data.

Removing and installing mounting block for pedals BMW 3 E36

Unscrew screw.Installation:

Tightening torque, 35 11 1AZD:

Type Thread Tightening specification Torque
1AZ Bearing pedestal to brake assembly and body
E38 / E39 / E52 31 Nm
E36 / E46 25 Nm
E53 / E65 / E66 / E67 / E60 / E61 / E63 / E64 / E83 Retighten 1x on brake booster after 30 min. 21 Nm
E85 / E86 M8 Retighten 1x on brake booster after 30 min 22 Nm
2AZ Bracket to bearing block
E85 / E86 M6 9 Nm

Removing and installing mounting block for pedals BMW 3 E36

Unscrew self-locking nuts.

Remove mounting block.

Installation:

Replace self-locking nuts.
Tightening torque, 35 11 1AZD.