BMW TIS Online
X

Remove and install, replace all spark plugs on engine BMW M73

12 12 011 

Switch off ignition.

Bank 1-6:

Press catch (2), disconnect plug (1).

Open clips (1).
Loosen the hose clamp (2) of the fresh air hose for the air pump.
Disconnect plug connection (3).
Unfasten hose clamp (4).
Remove the upper section of intake filter housing with hot film air mass meter.

Bank 7-12:

Open clips (1).
Unfasten hose clamp (2).
Disconnect plug connection (3).
Remove the upper section of intake filter housing with hot film air mass meter.

Disconnect plug connections (1 and 2) at the water valve.

Pull the water valve (1) out of the rubber mounts (2) and set aside to the bottom.

Loosen cable strap (1) and set air hose (2) aside to the bottom.

Cylinders 1-8

Use special tool 12 7 131 (extension) and special tool 12 1 171.

Cylinders 1-8

Installation note:

Tighten spark plug with special tool 12 1 171 and special tool 12 7 131 (extension), special tool 12 1 200 (torque limiter). Without special tool 12 1 200, note tightening torque. Tightening torque, refer to Technical Data 12 12 1AZ:

Type Thread Tightening specification Torque
1AZ Spark plugs (ungreased)
All M12x1.25 23 ± 3 Nm
All M14x1.25 30 ± 3 Nm

Cylinders 9-12

Use special tool 12 7 132 (extension) and special tool 12 1 171.

Cylinders 9-12

Installation note:

Tighten spark plug with special tool 12 1 171 and special tool 12 7 132 (extension), special tool 12 1 200 (torque limiter). Without special tool 12 1 200, note tightening torque. Tightening torque, refer to Technical Data 12 12 1AZ.


This post was last modified on November 23, 2017, 7:25 pm

Categories: 12 Engine electrical system
Tags: m73spark plugsv12
tisbimmer :
Disqus Comments Loading...

This website uses cookies.