Removal and installation, replacement release bearing, clutch fork BMW 5 E39

21 51 500

(Transmission removed)

Remove the release bearing (1).
Installation:
Clean all sliding surfaces on the clutch release bearing, check for damage and replace if necessary.
Clutch thrust bearing is not lubricated.
Surfaces (2) slip clutch release bearing must be flush to the surface (3) slip clutch fork.
Lightly grease the sliding surface (2) release bearing.
Grease, refer to. BMW Service Operating Fluids.
Изображение

Remove the spring clip (5) clutch fork (4), then remove the plug.
Installation:
Clean the clutch release fork.
Изображение

Lightly grease the clutch fork in only sliding surfaces (1 and 2).
Grease, refer to. BMW Service Operating Fluids.
Изображение

Installation:
Check spring bracket (5) and the pin (6) with a ball head for damage and replace if necessary.
Lightly grease the pin (6).
Grease, refer to. BMW Service Operating Fluids.
Note:
In S6S 420G transmission spring bracket and the pin must be replaced.
Изображение

Clean the guide sleeve (7).
A warning!
Guide bushings not lubricated.
Otherwise, if they are blocked at the release bearing guide sleeve.
Изображение