BMW TIS Online
X

Removal and installation, replacement brake pedal BMW 3 E46


Removal and installation, replacement brake pedal BMW 3 E46

35 21 000

A warning!
If you have installed the brake pedal without locking bracket (covering the stem of the piston of the working cylinder), it is necessary to replace it with a pedal with locking bracket.

Remove trim pedal assembly.
Remove the brake light switch.

The brake pedal without locking bracket

Remove the bracket and remove the piston rod.
Installation:
Wear a new bracket.
Both plate bracket should go to pin groove.
GM should mark a red dot bracket (1), thus confirming the correctness of its installation.

I unhook the return spring.
Remove the bracket (1) and remove the brake pedal bracket. If you want to fold up the casing (2).
Installation:
To put a new clip (1).

Installation:
Check and if necessary replace the sleeve (1) of the hinge.
Bushings (1) of the hinge lightly greased,
see. to BMW Service Operating Fluids.

Brake pedal with locking bracket
Remove the bracket (1).
Installation:
Use new clamp (1).

I unhook the return spring.
Remove the bushing (1) of the hinge of the brake pedal and press it to the left.
Heel pedal (2) down and remove it from the joint in the direction indicated by arrows.

Installation:
Check and if necessary replace the sleeve (1) of the hinge.
Bushings (1) of the hinge lightly greased,
see. to BMW Service Operating Fluids.


Categories: 35 Pedals
Tags: brake pedale46
tisbimmer :
Disqus Comments Loading...

This website uses cookies.