Removal and installation of the inlet pipeline. Engine M62
Note: The following is a description of the intake pipe cylinders №№ 1-6. Removal and installation of the cylinder intake manifold №№ 7-12 is similar.
1. Remove the fuel distribution manifold complete with injectors.
2. Disconnect the connector (1). Remove the screws on the throttle body, remove it without disconnecting the hoses, and take aside.
Изображение
Warning: If you install, replace the gasket between the pipe and the throttle body.
3. Check the laying of wires knock sensors (1 and 2) on the inlet pipeline.
Изображение
4. Remove the bolts acoustic system covers and remove it.
Изображение
5. Give nuts and move in the direction of high-voltage wires.
Изображение
6. Remove the screws on the intake pipe using the tool (nozzle) № 11 6060.
Изображение
7. Remove the bolts (1) securing the control valve of the engine crankcase ventilation system (the PCV) and remove it.
Изображение
8. If necessary, remove the vent pipe (1).
Изображение
Note: Pay attention to installation position of the ventilation tube (1) in the manifold (2).
9. Installation is the reverse order.