BMW TIS Online
X

Removal and installation of replacement water pump motor BMW M52, S52, M52TU, M54, M56

Removal and installation of replacement water pump motor BMW M52, S52, M52TU, M54, M56

11 51 000

Remove alternator drive belt.
Note:
M52, S52
Stopper for discharging coolant from the cylinder block is on the exhaust side between cylinders 4 and 5 (design).
M52TU, M54, M56
Stopper for discharging coolant from the cylinder on the downstream side in the 2nd cylinder.

Drain and dispose of coolant.
Installation:
Replace gasket.
Torque November 11 5AZ.
Vent cooling system and check for leaks.

Unscrew the mounting and remove the pulley.

Release screws on water pump.

Screw 2 bolts (M6) threaded holes in the water pump and uniformly extrude it from the timing case.

Installation:
Replace O-ring and cause coolant as a lubricant for easier sliding.

This post was last modified on September 20, 2016, 10:06 am

Categories: 11 Engine
Tags: water pumpwater pump m52water pump m52tuwater pump s52
tisbimmer :
Disqus Comments Loading...

This website uses cookies.