24 00 043

Drain automatic transmission fluid at oil drain plug.

Tightening torque 24 11 6AZ.

Important!

After completion of work, program transmission control unit.

Recycling:

Catch and dispose of escaping transmission fluid.

Observe country-specific waste-disposal regulations.

Important!

Before installing replacement transmission, always flush transmission fluid cooler together with lines.

After completion of work, check transmission fluid level.

Use only the approved transmission fluid

Failure to comply with this requirement will result in serious damage to the automatic transmission

Replacement transmission is supplied filled with transmission fluid

Necessary preliminary tasks:

Remove automatic transmission On vehicles with SCR system:

Modify nitrogen oxide sensor

Convert selector lever (1).

Tightening torque 24 51 1AZ.

Convert holder (2) for cable.

Modify transfer case.

Modify transportation locks.

Convert all cable holders.

Convert all seal plugs.

Convert protective cap on output shaft.

Important!

After removing transportation lock, secure torque converter against slipping out.

Transmission identification:

refer to BMW Parts Service

On type plate