11 00 … Service – engine oil (N57S1)
Special tools required:
11 4 650
Risk of scalding!
Carry out repair work on the vehicle only when wearing oil- and heat-resistant protective gloves incl. forearm protection, face guard and protective apron.
Carry out engine oil service only when the engine is at operating temperature.
Observe the exact engine oil filling capacity.
Overfilling the engine with engine oil will result in
Risk of damage!
When performing repair work on the engine oil, coolant or fuel circuit, it is essential always to protect the alternator against dirt contamination.
Cover alternator with suitable materials.
Catch and dispose of drained engine oil in a suitable collecting vessel.
Observe country-specific waste disposal regulations.
Release oil filter cover with special tool 11 4 650 .Note: Engine oil flows out of the oil filter housing and back into the oil sump.
Release push-button (1).
Open and close service opening (2) in direction of arrow.
Open oil drain plug (1) of oil sump and drain engine oil.
Tightening torque 11 13 1AZ.
Replace sealing ring.
Pull out oil filter element (2) in direction of arrow.Installation note:
Replace oil filter element (2) and sealing ring (1).
Moisten sealing ring (1) on oil filter cover and sealing ring (3) on oil filter element guide with engine oil.
Observe the guide bore (1) for oil filter element in oil filter housing (2).
Secure oil filter cover (1) with special tool 11 4 650 .
Tightening torque 11 42 1AZ.
Pour in engine oil.
Start engine and run at idle speed.
Switch off engine.
Check oil filter cover (1) and screw plug on oil sump for tightness.
Checking oil level:
Park vehicle on a horizontal surface
Using the oil dipstick, check the engine oil level after five minutes on the engine at operating temperature
Top up engine oil if necessary
For informational purposes only. Disclaimer>>