BMW TIS Online
X

Adjusting the throttle control cable BMW engine M52


Adjusting the throttle control cable BMW engine M52

35… 41

Manual shifting:
Connect DIS or MoDiC to the diagnosis connector and select Diagnostic program / Engine Electrical / Diagnosis requests.
1. The accelerator pedal in the idle position
2. Throttle in idle position

3. Adjust valve via the control cable adjusting bolt (1) in such a way that it is clearly perceptible gap in the mechanism of the cable (max .: 3 mm).

4. Adjust the adjusting screw on the palm of the accelerator pedal at maximum throttle so that it touches the pedal at full engine load and ensures throttle opening angle between 80Ai 84A
5. Lock the M8 nut on the stop full throttle.

Automatic transmission:
Connect DIS or MoDiC to the diagnosis connector and select Diagnostic program / Engine Electrical / Diagnosis requests.
1.-3. cm. Manual gearshift
4. Adjust the point of switching Kick-down mode in such a way as to ensure throttle opening angle between 76Ai 80A
5. Lock the nut abutment Kick-down.
6. Check mode Kick-down:
Press the accelerator pedal to the inclusion of point Kick-down mode. throttle opening angle should be between 88A 84Ai
7. Checking the inclusion downshift under full load as follows:
Select Diagnostic program / Automatic transmission / Diagnosis requests.
Press the accelerator pedal is close to the mode switching point Kick-down. throttle opening angle must be 100%.

Categories: 35 Pedals
Tags: control cablem52throttle
tisbimmer :
Disqus Comments Loading...

This website uses cookies.