Adjusting the throttle control cable BMW engine M43

35… 41

Manual Transmission:
Connect DIS or MoDiC to the diagnosis connector and select Diagnostic program / Engine Electrical / Diagnosis requests.
1. The accelerator pedal in the idle position
2. Throttle in idle position

3. Remove the adjusting nut (1) on the throttle cable until until it starts to change the value of idle throttle potentiometer. Adjust the position of the throttle to 0%.
Screw the adjusting nut (1) a quarter turn.
Изображение

4. Adjust the adjusting screw on the palm of the accelerator pedal at maximum throttle so that it touches the pedal at full engine load and throttle position provide between 94% and 98%.
5. Lock the M8 nut on the stop full throttle.
Изображение

Automatic transmission:
Connect DIS or MoDiC to the diagnosis connector and select Diagnostic program / Engine Electrical / Diagnosis requests.
1.-3. cm. Manual transmission
4. Adjust the point of switching the maximum acceleration mode so as to ensure the throttle position between 83% and 87%.
5. Lock the nut abutment Kick-down.
6. Check mode Kick-down:
Press the accelerator pedal to the inclusion of point Kick-down mode. Throttle position should be between 94% and 98%.
7. Checking the inclusion downshift under full load as follows:
Select Diagnostic program / Automatic transmission / Diagnosis requests.
Press the accelerator pedal is close to the mode switching point Kick-down.
Accelerator pedal position must be 100%.