Removing and installing, sealing, replacing full-flow oil filter assembly BMW M62 engine, S62

11 42 020
Full-flow oil filter cover to turn on and tighten only using the socket wrench with interchangeable head.
When the main flow oil filter cap is drained from the filter housing into the oil sump.
Release main flow oil filter cover and remove upwards.
Installation:
Torque,
cm. Technical Data 11 42 2AZ.
Изображение

Disconnect the removable element (1) from the main flow oil filter cover and replace.
Installation:
Replace ring (2) of circular cross section and lubricate it with oil.
Replacement element (1) must audibly engage in the full-flow oil filter cover.
Изображение

Disconnect the connector from oil pressure switch.
Release oil lines holders.
Remove oil lines from main flow oil filter housing.
Disconnect the drain oil line from full-flow oil filter housing.
Installation:
Replace the O-rings of the drain oil line.
Torque,
cm. Technical Data 11 42 5AZ.
Изображение

Installation:
Replace O-rings and lubricate them with oil.
Изображение

Release nuts (1).
Release screw (2) and disconnect ground connection from the main flow oil filter housing.
Remove full-flow oil filter housing.
Изображение

Installation:
When installing the full flow oil filter housing insert the locking pin (1) into the fixing opening (2).
Изображение