33 10 053 

Warning!

Risk of burning if exhaust system is touched!
Danger of poisoning if oil is ingested/absorbed through the skin!
Danger of injury if oil comes into contact with eyes and skin!

Removal:

Removing and installing, replacing temperature sensor on rear axle final drive / output shafts BMW M2 F87

Important!

Have new part ready to avoid unnecessary escape of differential oil.

Disconnect plug connection (1).

Loosen temperature sensor (2) from oil sump (3).

Installation:

Removing and installing, replacing temperature sensor on rear axle final drive / output shafts BMW M2 F87

Screw the temperature sensor (2) into the oil sump (3).

Tightening torque 33 11 4AZ:

Type Thread Tightening specifications Torque
1AZ Drive flange hub to output shaft
F80 / F82 / F83 / F87 M27 Renew nut. 300 Nm
2AZ Wheel bearing to wheel carrier
F80 / F82 / F83 / F87 M12 Renew screws.
Jointing torque 80 Nm
Angle of rotation 90 °

Connect connector (1) to temperature sensor (2).

Clean rear differential.

Required follow-up work:

Check oil level, correct if required.