Removing and installing, replacing left or right rear light BMW 5 E60
63 21 180
Follow instructions for protection against electrostatic discharge (ESD – ElectroStatic Discharge).
Necessary preliminary tasks:
Remove the luggage compartment trim panel on the left wing.
Disconnect the connector (1).
Release nuts (2) and remove the rear light unit (3) traffic outside.
Observe the tightening nut 4.
Tightening torque 63 21 1AZ.
With the nut (4) is regulated by size of the gap relative to the wing.
When tightening the bolts to avoid tensions in the rear light unit.
Pay attention to the correct position of the seal (1) rear light, replace the seal if necessary.
Check whether the thrust buffer (3) rear light set (2).
If necessary, replace the rear light housing cartridges.