35 11 000 

Important!
After completion of work, carry out function check.

Necessary preliminary tasks:
Remove pedal trim panel

Removing and installing (replacing) complete bearing support for foot pedal BMW X5 E70

Release screws (1).
Remove air duct (2).

Removing and installing (replacing) complete bearing support for foot pedal BMW X5 E70

Disconnect plug connection (1).
Remove retaining clip (2) and pull out locking pin in direction of arrow.

Removing and installing (replacing) complete bearing support for foot pedal BMW X5 E70

Unscrew nuts (1).

Installation note:

Replace self-locking nuts.

Tighten nuts (1) such that bearing support can still be moved.

Make sure bearing support is correctly seated on body.

Tighten nuts (1).

Tightening torque 35 11 1AZ:

Type Thread Tightening specifications Torque
1AZ Bearing pedestal to brake assembly and body
E70, E71, E72 M8 Retighten 1x on brake booster after 5 min 24 Nm
2AZ Bearing support to bracket, top
E70, E71, E72 M8 24 Nm

Removing and installing (replacing) complete bearing support for foot pedal BMW X5 E70

Remove left partition wall for units compartment.

Unclip retaining bracket (1) and remove both brake lines (2) from guides.

Important!

Do not bend brake lines.

Pull brake master cylinder with brake servo 30 mm forwards.

Installation note:

Retighten brake lines on brake master cylinder.

Tightening torque 34 32 1AZ:

Type Thread Tightening specifications Torque
1AZ Bearing pedestal to brake assembly and body
E70, E71, E72 M8 Retighten 1x on brake booster after 5 min 24 Nm
2AZ Bearing support to bracket, top
E70, E71, E72 M8 24 Nm

Feed out bearing support for pedal mechanism.

Replacement:

Modify brake light switch
Modify brake pedal spring
Modify pedal rubber