Removing and installing front or rear wheel drive BMW

36 10 300

Special tools required:
36 1250

A warning!
Wheel balancing was performed on an electronic bench.

To avoid errors in the consolidation and connected to this imbalance, proceed as follows:
– Loosen the wheel bolts.
– The position of the wheel – down valve.
– Apply the timing marks (eg, chalk) on the tires when the wheel is removed a few at a time.
– Mark the position of the wheels relative to the hub.
– Mark the position of the bolt with “sekretki” relative to the wheel.
– Remove the wheel bolts and remove the wheel.
Изображение

A warning!
The contact surfaces of the brake discs and wheel and brake disc and wheel hub must be free of grease.
Clean contact surface (1) of dirt, grease and rust using a drill device 36 and 1250.
A warning!
Run the tool 36 1 250 with pulse screwdriver forbidden!
Note:
Clean contact face with universal cleaner, refer. To BMW Parts Service.
Note:
If you have a hole in the grease for the wheel bolts must be removed and clean the brake disc.
Изображение

Clean contact surface (1) of dirt, grease and rust using a drill device 36 and 1250.
A warning!
Run the tool 36 1 250 with pulse screwdriver forbidden!
Note:
Clean contact face with universal cleaner, refer. To BMW Parts Service.
Изображение

Check the screw (1) of the brake disc mounting tightness.
A warning!
brake disc fastening screw in any case should not protrude beyond the plane of the (2) coupling brake and wheel discs.
Tightening torque of the brake disc mounting screws:
on the front axle, see. 34 11 1AZ.
on the rear axle, see. 34 21 1AZ.
Изображение

Lightly grease the centering element (1) Rim.
Note:
see. to BMW Operating Fluids, Main Group 36.
Изображение

Wheel bolts with a cone:
a) galvanized Wheel bolt
b) black chrome wheel bolt
c) Black chrome bolt “sekretki”
g) black chrome bolt “sekretki” and adapter
Note:
Use a suitable adapter To release and tighten the bolt “sekretki” of the device 36 1 300 (adapter kit for wheel bolts).
Изображение

Clean wheel bolts and check the thread for damage and replace the bolts if necessary.
Replace screws with corrosion.
A warning!
Do not lubricate the new wheel bolts.
In finding a used wheel bolt before screwing lightly grease the threads and a tapered portion (motor oil).

A warning!
For screwing and tightening wheel bolts in any case not to use pneumatic or electric tool.

A warning!
Wheel drive must adhere uniformly to the brake disc.
Screw in wheel bolts and tighten them by hand in a crisscross pattern to center the wheel rim.
Tighten the wheel bolts crosswise with a torque wrench.
Tightening torque, see. 36 10 1AZ.
Изображение